G-Technology G-Speed eS Pro Uživatelská příručka stáhnout pdf (Strana 35)

Maintenance for Your Drive

p.35

Maintenance for Your Drive

WARNING: Make absolutely sure that you remove the correct drive as indicated in

the steps below.

REMOVING THE WRONG DRIVE CAN RESULT IN THE LOSS OF THE ARRAY AND

ALL OF THE CONTENT STORED ON G-SPEED ES PRO.

5. The failed drive’s LED will begin to blink in the

G-SPEED eS Pro enclosure, making it easy to

identify which drive needs to be replaced. Be

certain to remove the correct drive, as removing

the wrong drive could cause data loss.

NOTE: It is possible the failed drive will be com-

pletely ofine. In this case, the drive’s Activity LED

will be completely turned off, indicating the failed drive.

6. Remove the failed drive by inserting the provided key into the Lock hole and

sliding the drive out of the enclosure.

7. Replace the failed drive with a new disk module and secure in place. Once the

drive has spun up to speed, the CongTool will indicate that the array is rebuild-

ing. The rebuild time is approximately 1 hour per TB.

Once the rebuild is complete, G-SPEED eS Pro is back to normal, protecting your

valuable data once again.

NOTE: Replacement and/or extra G-SPEED eS Pro disk modules are available for

purchase online at: www.g-technology.com/Products/g-speed-es-pro.cfm

Drive Activity LED

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 50 51

Žádné komentáře

G-Technology G-Speed eS Pro Uživatelská příručka Strana 35